This therefore results in the tensile strain data going up to 2% strain then no further data is available for the remaining extent of the curve - so no information on the 2% to 100% strain ,or to break off point. The tensile strain data only goes up to 2% strain due to limitations of the extensometer. I am however looking for True Stress/Strain values to input in to ANSYS. These are Engineering Stress/Strain values provided by our testing house (raw data). I have Tensile Strain (mm/mm) data and Tensile Stress (MPa) data. I have a set of mechanical tensile test data in which I wish build material models in ANSYS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |